Home
My Puzzles
FAQ
Report bug
Collected Puzzles
User listed puzzles
Random Puzzle
Log In/Out

Radio Test

DM

Radio Test

1
2               3   4  
  5  
6 7         8         9  
           
10                                          
         
      11            
12               13
       
  14        
     
  15      
   
16   17      
    18        
       
     
  19     20  
     
21        
 
 
22  
23            
 
24        

Across
2.What is the nomenclature for part number RG213U?
3.This is the system used to fill out a purchase request.
7.Which B+ voltage is normally at 18 +/- .4VDC in the AN/GRR-23/24?
10.AGC stands for what?
11.Para 5-29 is titled what?
12.This the the WUC for the AN/GRR-23.
14.Emergency operation is covered under what chapter for the AN/GRT-21/22?
15.Using a AN/GRT-21 in the 10 watt mode, which RF output is used?
16.If you have a squelch voltage of 8 VDC which type of configuration AGC/squelch module do you have?
18.Total realignment of a receiver is required if the unregulated B+ is adjusted (T/F)?
19.What reading do you look at when determining a receivers "signal-plus-noise to noise ratio"?
21.The AN/GRR-24 operates in the VHF frequency range (T/F)?
23.Which cable on between the exciter and LPA directs the RF power to the proper EL relay output?
24.What color tag is used for turning in bad parts to out logistice people?
Down
1.This is a type of T.O. to locate the part numbers when ordering parts.
4.While performing the frequench accuracy test of the AN/GRR-24 you connect the CSM to what module?
5.This is the system used for locating the NSN and cost of an item.
6.What front panel jumper is removed during testing to connect test equipment to the AN/GRR-23?
8.What WUC is used to document in IMDS the replacement of an RF cable on a AN/GRC-171?
9.UHF TUNING AND POST TUNING CHECKOUT for the AN/GRR-23/24 is covered in which QTP module?
13.Tuning procedures for the AN/GRT-21/22 are covered in what chapter?
17.What switch position causes the LPS reverse meter reading to peg negative?
18.T.O. 31R2-2GRT-104 where you can locate the tuning procedure of the AN/GRT-21/22 (T/F).
20.The DMM is set to read what type of voltage when connected between the IF and ground test points?
22.AGC is read as what type of voltage?

Use the "Printable HTML" button to get a clean page, in either HTML or PDF, that you can use your browser's print button to print. This page won't have buttons or ads, just your puzzle. The PDF format allows the web site to know how large a printer page is, and the fonts are scaled to fill the page. The PDF takes awhile to generate. Don't panic!




Google
 
Web armoredpenguin.com

Copyright information Privacy information Contact us Blog