1
		2				3
													4
5															6
							7			8											9
	10		11
									12
																			13
					14
	15
												16		17
							18
	19
									20
					21
					22

Across 1. Slag left on a weld can cause lack of __________ on the next pass 3. Slag is removed using a chipping ___________ 5. The coating on the electrode 8. SMAW requires a constant _____________ power source 10. E7018 has 70,000 psi of ____________ strength 17. Type of weld bead with very little side to side motion 19. The "E" in E6013 stands for this 20. E7024 contains __________ powder in the coating 21. E6010 is a deep ________________ electrode 22. The last digit in an electrode number designates coating and ____________

Down 1. Steel, stainless,and cast iron are all ___________ metals 2. E6010 uses a whip and __________ motion 4. Distance from the root to the face 6. Gap left at the toe of the weld not filled in with weld metal 7. Type of weld bead run with significant side to side motion 9. Amperage too high will cause excessive ____________ 11. We run E6013 on DC electrode ______________ 12. E7018 is a low ____________ electrode 13. Coating left on weld bead 14. The third number of an electrode designates its _______________ 15. Electrode size is measured by _______ ________ diameter (2 words) 16. The gap between the electrode and base metal when welding (2 words) 17. As the flux coating burns it produces ___________ gas to protect the weld 18. E7024 can only be used for flat and ________________ welds