1								2		3
						4
							5										6
										7
												8						9
				10	11
												12	13
												14
				15				16
		17
										18
19
										20					21
									22			23						24
							25
						26
														27
							28										29

Across 2. The ___ grain is against the fence when edge jointing. 4. Turn off a machine ___ if it sounds wrong. 6. ___ knots should not be run through the planer. 7. Get ___ instructions before using a machine. 8. The maximum depth of cut on a jointer is ___ inch. 10. ___ sawing is not allowed on the table saw. 12. A blade that will both crosscut and rip is called a ___ blade. 14. The rip ___ supports wood ripped on the table saw. 15. The ___ gage supports wood crosscut on the table saw. 17. Tie back ___ hair. 18. Remove special ___ when finished using it. 19. The RPM for large diameter drill bits on the drill press. 22. Be careful not to get it caught in spinning machine parts. 26. Never ___ in line with a machine blade. 27. Remove all ___ before using a machine. 28. The planer handwheel raises and lowers the ___. 29. Stand to the ___ of the jointer while using it.

Down 1. Make all ___ while the saw is stopped. 3. Cutting a board across the face grain is called ___. 5. The ___ jointer table is the same heigth as knives. 9. Keep all safety ___ in place on machines. 11. Cutting a board with the face grain is called ___. 13. Raise the table saw blade ____ inch above the wood. 16. Never ___ over the table saw blade to get a board. 17. Never ___ into the planer. 19. Use a push stick for ripping boards ___ inches or less. 20. The ___ on the table saw can be tilted. 21. The ___ jointer table adjusts the depth of cut. 23. The width of a board run across the jointer should be at least ___ inches. 24. The length of a board run across the jointer should be at least ___ inches. 25. Never ___ a machine for another student.